STRAIGHT OLYMPIC BAR | ATX® POWER BEARING BAR
Model: LH-50-ATX-NB
ATX® offers the highest quality, tested and proven equipment for professional use.
Olympic bar 220cm LH-50-ATX-NB ATX® Power Bearing Bar is made of special elastic steel. It is a key element in the construction of the neck. Precision-made bars are characterized by high compressive and tensile strength. At the same time, they retain their advantages of flexibility.
The LH-50-ATX-NB 220cm Olympic Bar is prepared for professional use where flexibility is crucial during training. The neck is deformed to a value that limits its flexibility. It then resiliently returns to its initial state without being permanently deformed.
Its unique elastic properties are due to the optimal combination of chromium, molybdenum, silicon and manganese. The high quality is confirmed by tests carried out by an independent German laboratory, which has carried out the following tests:- Tensile test according to EN ISO 6892-1 standards
- Rockwell hardness acc. To EN ISO 6508-1 standards
The ATX® neck has the following values:
- tensile strength: 206,000 psi = 206 K (K / NSI = k.pounds per square inch) = 1,420 N / mm 2
- surface hardness / HRC: 44.0
220cm Olympic Bar LH-50-ATX-NB ATX® Power Bearing Bar for use in crossfit training, weightlifting and even powerlifting. The bar can be used in the most extreme training conditions, where the highest product quality is crucial.
Material: | resilient solid steel according to EN 10277-5 chromium-molybdenum-silicon-manganese alloy |
Maximum load: | 700 kg (see restrictions details below) |
Libra: | 20 kg ± 0.2% |
Total length: | 2200 mm |
Grip Length: | 1310 mm |
Working part diameter: | Ø 50 mm, with a fine non-slip finish |
Grip Diameter: | Ø 28 mm |
Rotary sleeves: | precise, bearing 4 needle bearings in each sleeve |
Grip surface: | precise finished surface subjected to the knurling process with double marking of the grip length |
Center Mark: | without center knurling |
Grip marker: | 810 mm | 910 mm |
Surface coating: | high-quality chrome coating with high abrasion resistance hard chrome plating |
Fitness type training | |
Strength training | |
Weightlifting | |
Powerlifting |
Permissible bar load:
The stated maximum load capacity of the Olympic bar is based on optimal training conditions. The user must be aware of the fact that the permissible load changes with the change of the support points, which have been marked in the schematic drawing. The relationship is directly proportional to the change in the distance of the support points among themselves.
Attention !!
Improper loading of the bar may lead to its permanent damage, which is not covered by the guarantee and warranty.
Permissible load depends on the application
Type of load transfer | Maximum load | Sample exercises |
Wide handle | maximum load | 700 kg | bench press |
Medium handle | reduced load | 600 kg | deadlift |
Middle handle | minimum load | 500 kg | squats |
Data sheet content
Dane techniczne | wymiary
- Total length
- 220 cm
- Grip length
- 131 cm
- The length of the working part
- 2x 415 mm
- Gripping diameter
- ∅28 mm
- The diameter of the working part
- ∅50 mm
- Weight limit
- 700 kg
Gwarancja
- Consumer Warranty:
- 36 miesięcy
- Light Commercial Warranty:
- 24 miesiące
- Commercial Warranty:
- 24 miesiące
20 other products in the same category:
arrow_upward